Warm Conductivity of Liquids The mechanical assembly is intended to decide warm conductivity of various fluids. The device comprises of a radiator. The radiator warms a thin layer of fluid. A cooling plate expels warm through fluid layer, guaranteeing unidirectional warmth stream. Temperature is estimated over the fluid layer and finish get together is appropriately protected. A properarrangement for changing the fluids is given. The entire get together is kept in a chamber. EXPERIMENTATION: Ø Determination of warm conductivity of fluid. Ø Study of variety of warm conductivity of fluid with temperature.UTILITIES REQUIRED :Ø Water supply 5 lit/min (approx.) Ø Drain. Ø Electricity Supply: 1 Phase, 220 V AC, 2 Amp. Ø Table for set-up support.TECHNICAL DETAILS :Ø Liquid Chamber : Dia 160 mm (approx). Ø Heater : Dia 100 mm, sandwiched between copper plates. Ø Insulation : Ceramic Wool Ø Cooling chamber : Made of Aluminum for water flow. Ø Digital Voltmeter : 0-300 Volt. Ø Digital Ammeter : 0-2 Amp. Ø Variac : 0-230 V, 2 Amp. Ø Digital Temp. Pointer : 0-199.90C, with multi-channel switch Ø Temperature Sensors : RTD PT-100 compose. Ø Instruction Manual : An ENGLISH guideline manual will beprovided alongside the Apparatus Ø Valves are accommodated deplete, charging & flood line to make framework adaptable. Ø MS Cabinet to suit the piece get together. Ø The entire setup is mounted on a powder covered base plate .